Pc Case Mods

any one done any? if so what you done? pics would be cool i am rather new to it but hope by the end of the year to have a nice looking pc tower =) just got 2 new 80mm spider fan grills and a uv blue handle =)

 

i've doen a few simple ones

spay painting interior/back
cutting a small holeto help w/ cabel mangement


right nwo I'm considering either buying a new case or doing some mods to add fans.

 

sounds nice could add a water cooler =) dare you

 

lol you wouldnt have to dare him, its a lot cheaper to addd a couple fans then to buy a water cooling system.

if xelink gets water he will control the world..... its that simple haha

 

water is far more better looking then fans tho =) you seen them water cases omg just lush

 

yea but lighted fans are trippy as hell

 

i have water cooler

s3xy tooo...

but no camera sry

 

my case is too small for water cooling.

and I can still go a fair amount higher on air.

I could probably get 3.6-3.7GHz(CPU) out of this system by swap some yate loons in to improve airflow, and adding a thermal right HR-05 SLI northbridge cooler.

at this moment, I'm running at 3.366GHz on the CPU(421FSB) and I'm running benchmarks to test

no voltage increases yet heh...


to be fair, I need the following to rule the world

quad core XE CPU
rd600
h20 cooling
half a doezen TECs
Custom 3500W PSU w/ 260A on the 12V rails.
4GB DDR3 RAM on DDR2 interface(for obvious reasons)
three R600 cards
scsi controller
5 15k RPM scsi drives
128GB solidstate memory

 

lmao, good luck getting all that ^_^

 

wow hes honest too

xelink for pres? i think so haha off to the bar i go.