Recently, my computer got crashed. I took out the hard drive and put it in the other computer. It says new data found, but when I go to My Computer, it isnt there. Can anyone help me?
try to give the drive a letter heres how its done (done on win xp) if you go to my computer and hard dive is not there this will work..., To assign, change, or remove a drive letter Using the Windows interface Open Computer Management (Local). In the console tree, click Disk Management. Where? Computer Management (Local) Storage Disk Management Right-click a partition, logical drive, or volume, and then click Change Drive Letter and Paths. Do one of the following: To assign a drive letter, click Add, click the drive letter you want to use, and then click OK. To modify a drive letter, click it, click Change, click the drive letter you want to use, and then click OK. To remove a drive letter, click it, and then click Remove. Important Be careful when making drive-letter assignments because many MS-DOS and Windows programs make references to a specific drive letter. For example, the path environment variable shows specific drive letters in conjunction with program names. Notes To open Computer Management, click Start, and then click Control Panel. Click Performance and Maintenance, click Administrative Tools, and then double-click Computer Management. You must be logged on as an administrator or a member of the Administrators group in order to complete this procedure. If your computer is connected to a network, network policy settings might also prevent you from completing this procedure. A computer can use up to 26 drive letters. Drive letters A and B are reserved for floppy disk drives, but you can assign these letters to removable drives if the computer does not have a floppy disk drive. Hard disk drives in the computer receive letters C through Z, while mapped network drives are assigned drive letters in reverse order (Z through B). You cannot change the drive letter of the system volume or boot volume. An error message may appear when you attempt to assign a letter to a volume, CD-ROM drive, or other removable media device, possibly because it is in use by a program in the system. If this happens, close the program accessing the volume or drive, and then click the Change Drive Letter and Paths command again. Windows 2000 and Windows XP allow the static assignment of drive letters on volumes, partitions, and CD-ROM drives. This means that you permanently assign a drive letter to a specific partition, volume, or CD-ROM drive. When you add a new hard disk to an existing computer system, it will not affect statically assigned drive letters. letters.
u can also format ure HDD after u recoverd ure data, u can recover ure data with this program: Stellar_Phoenix_FAT_NTFS_v2[1].0
Put the CD that came with your drive in, and then run the utility, You dont have to use it very often, but on some instances you do. I ran into this a while back, now no issues.
those r good ideas and if they still dont work do wat i do...burn the harddrive (litteraly) and get aa new 1
depends on windows version really, but to be on the safe side install the drivers/software that comes with the drive
Sorry, but its possible that theres a hardware problem. Perhaps the harddisk has failed completely, or it has insufficient power.